How do I assemble the Strap?

Strap assembly is easy. Follow the steps below. 





Step 1. Take the strap with the seam facing to the back. 

IMG_3589.JPG

Step 2. Take the end of the strap and slide it under the bar on the left side. Wiggle it back and forth to work it under the bar. 


IMG_3591


Note: If it is tight use a small pointed object to work it under the bar. A small screw driver works or even a key. 
IMG_3593

Step 3: When enough of the strap has been pushed under the bar hold the strap and pull it through so that it passes the end of the hook (the prickly/non fuzzy part) portion of the Velcro. 


IMG_3594


IMG_3595

 Step 4: Put the right side through using the method above. Once at this stage slide your hand into the strap to see how it fits. Pull on each side to tighten to your liking. (Shops: Make it a medium tightness.)

IMG_3596


 Step 4: Once it is in place, pull the neoprene cover back on the left side and firmly press the Velcro on itself. (Press all along the Velcro so it gets a nice strong stick.)

IMG_3597.JPG


Step 5: Slide the neoprene back over and check to be sure the Velcro didn't catch on the neoprene and curl back.  
IMG_3605

If it did curl back use the screw driver to slide under the neoprene and push back the Velcro and press everything down with you thumb until everything is flat. 
IMG_3606

Step 6: Add the hang tag if you are a shop and attach the right side the same as the left. 

IMG_3599.JPG

IMG_3600


 Step 7: Take a break. You deserve it!

IMG_3604





See Older Posts...